Clik here to view.
Pro Time Lapses
This video on Vimeo is absolutely amazing! It is a combination of day and night shots that were taken in Yosemite National Park. This next video is also a collection of shots from Arizona and Utah....
View ArticleClik here to view.
Gertboard Arrived!
My gertboard arrived today! So I setup the soldering stuff and went to work on the practice board from Elenco that I bought from Amazon. And I found out real quick that the soldering iron that I have...
View ArticleClik here to view.
Pandora Internet Radio – In a portable box
Great tutorial here on Instructables on how to build a portable Internet radio box. This project includes some soldering, but has good instructions. I am going to look into installing pianobar as that...
View ArticleClik here to view.
GPIO Computer Case Fan and LED Cube
My 5V computer case fan arrived and I was very interested to see if I could power it from the Raspberry Pi. So I turned everything off, and plugged it into the GPIO cable. I had put the case back...
View ArticleClik here to view.
RasPiLapse
Below is a link to the raspberrypi.org site that has an article about Rick Adam who has created a timelapse dolly for way less than a professional rig would cost. The setup uses a raspberry pi to drive...
View ArticleClik here to view.
Building a Gertboard
Finally edited the time lapse of building my Gertboard. It took about 4-5 hours from start to finish. I missed a small portion of soldering the header pins because the camera ran out of battery. The...
View ArticleClik here to view.
Finished and Uploaded!!
The video of the compilation of over 3 months is edited and uploaded! It has been 3 months since I setup the Canon PowerShot camera and Raspberry Pi in the greenhouse to watch the plants grow. And grow...
View ArticleClik here to view.
Gertboard LED test scripts
I originally tested the Gertboard using the C code. But then when it came to modifying it I am not very familiar with C. So I downloaded the Python code available here from raspi.tv and it worked...
View ArticleClik here to view.
Hypnocube
I recently found the Hypnocube 4Cube, which is a grid of 64 RGB (Red/Green/Blue) LEDs laid out 4 LEDs wide, by 4 LEDs long, by 4 LEDs high. Pictures are at the bottom of this post. I wrote a little bit...
View ArticleClik here to view.
LED Notification Light Box
The Hypnocube was a great project and I am very happy with it. It is amazing to just turn on and watch it! But I was never able to figure out how to program it to my own custom animations. I have not...
View Article
